新闻中心

新闻中心

NEWS CENTER
>
>
>
How to solve the problem of low ozone concentration in China Ozone Disinfector

How to solve the problem of low ozone concentration in China Ozone Disinfector

(Summary description)Just air and oxygen. The type of oxygen is generally provided by an oxygen cylinder or an oxygen generator. Air compressors generally use clean and dry compressed air as the raw material.

How to solve the problem of low ozone concentration in China Ozone Disinfector

(Summary description)Just air and oxygen. The type of oxygen is generally provided by an oxygen cylinder or an oxygen generator. Air compressors generally use clean and dry compressed air as the raw material.

Information

Just air and oxygen. The type of oxygen is generally provided by an oxygen cylinder or an oxygen generator. Air compressors generally use clean and dry compressed air as the raw material. Since the ozone layer is produced by oxygen, the oxygen content in the air is only 21%, so the ozone concentration produced by the air generator is relatively low, and the purity of the bottled oxygen generator or the oxygen generator is above 90%, so the oxygen generator The ozone concentration is very high.

China Ozone Disinfector

The type of gas generally uses air (such as compressed air) as the raw material. Because the ozone layer is dependent on oxygen, which is only 21% oxygen in the air, the air generator produces a lower concentration of ozone, which also generates nitrogen compounds. However, the oxygen purity of the oxygen cylinder or oxygen generator is above 90%, so the ozone concentration in the oxygen generator is relatively high. Air generators are often used for environmental disinfection. When carrying out water treatment, oxygen-type generators should be preferred.

If the ordinary China Ozone Disinfector is purchased and used for a period of time, the concentration of the ozone layer decreases and the desired sterilization effect cannot be achieved, so it is possible to purchase the low-end China Ozone Disinfector. Moreover, the ozone concentration output by the high-end dual-core China Ozone Disinfector is very stable, which can achieve 99% sterilization effect, and can be detected by a handheld ozone machine after sterilization.

The amount of ozone refers to the proportion of ozone per unit volume. The selected units are mg/L, g/m3, and the volume ratio units are 1%, 5%, etc. The health department commonly uses ppm. The above units are often used to indicate the outlet concentration or atmospheric ozone concentration of China Ozone Disinfector. The amount of ozone represents the sum of the weight of ozone per unit volume when the ozone device is produced. The larger the value is, the faster the ozone production equipment is to produce ozone. Because the ozone layer is unstable and breaks down on its own, it needs to be readily available.

It is an important basic technical index for the calibration of the output of China Ozone Disinfector in sewage by starting the small China Ozone Disinfector manufacturer "Qingdao Gonow China Ozone Disinfector", and its output is calculated by measuring the ozone concentration, Strictly speaking, if there is no reliable method to measure, it is impossible to produce a qualified product. At present, there are false alarms and false alarms in the production of China Ozone Disinfector in the market, the main reason is that the ozone concentration index is untrue.

4. It is generally recommended to enter the clean area to conduct ozone concentration detection by time period. China Ozone Disinfector will be tested once after 30 minutes of operation, and China Ozone Disinfector will be tested once after 60 minutes of operation. If necessary, then test again at 90 minutes and 120 minutes. Generally, China Ozone Disinfector can detect the ozone concentration immediately after working for 30 minutes, and work normally for 1 hour; if the ozone concentration cannot be detected or is low, it is necessary to detect whether the ozone has entered the pipeline, or there is leakage of ozone; if there is leakage of ozone, it will cause The ozone concentration is low; if the ozone concentration in the detected air is too high, the sterilization time should be controlled.

Ozone is generated in the gap between the inner and outer electrode compartments of the ozone machine, and the output of ozone can be collected centrally in higher concentrations, for example, for water treatment. The electrodes of the open-type generator are exposed to the air, and the generated ozone is directly diffused into the air. Due to the low ozone concentration, it is generally only used for air in a small space, or for sterilizing the surface of some small items. This device can replace the gap discharge used by open generators. However, the cost of gap discharge China Ozone Disinfector is higher compared to open circuit.

Keyword:

Scan the QR code to read on your phone

img
  • Hotline: 400-187-6068

  • Phone: 0755-82727906

  • Address:Block E, Zhongji Low Earth Orbit Satellite Industrial Park, Keneng Road, Dongkeng Community, Fenghuang Street, Guangming District, Shenzhen

公众号二维码

Scan QR code

language
中国
韩国
韩国
韩国
韩国
韩国

Copyright: Shenzhen Sanai Health Technology Co., Ltd.    粤ICP备2021002090号   SEO标签