China Ozone Disinfector generally uses electrolyzed purified water to generate ozone. The generator can produce high-concentration ozone water, has low production cost, and is simple to use and maintain. However, because the amount of ozone cannot be increased, the life of the electrode is short, and the ozone is not easy to collect, and the scope of application is also very limited. At present, China Ozone Disinfector is only suitable for some special small equipment or special places, and does not replace the high voltage discharge generator.

The type of oxygen is generally provided by oxygen cylinders or China Ozone Disinfector. Air compressors generally use clean and dry compressed air as the raw material. Since the ozone layer is produced by oxygen, the oxygen content in the air is only 21%, so the ozone concentration produced by the air generator is relatively low, and the purity of bottled China Ozone Disinfector or oxygen generator is above 90%, so the oxygen generator The ozone concentration is very high.

China Ozone Disinfector can strengthen the ozone treatment of toxic and harmful substances in the air, and at the same time, its internal air duct and pipeline installation can also realize that the concentration of dust and suspended solids in the flue gas does not exceed the standard, and there is no ozone and scale inhibition.

The type of gas generally uses air (such as compressed air) as the raw material. Because the ozone layer is dependent on oxygen, which is only 21% oxygen in the air, the air generator produces a lower concentration of ozone, which also generates nitrogen compounds. However, the oxygen purity of the oxygen cylinder or oxygen generator is above 90%, so the ozone concentration in the oxygen generator is relatively high. Air generators are often used for environmental disinfection. When carrying out water treatment, oxygen-type generators should be preferred.

4. It is generally recommended to enter the clean area to conduct ozone concentration detection by time period. China Ozone Disinfector will be tested once after 30 minutes of operation, and China Ozone Disinfector will be tested once after 60 minutes of operation. If necessary, then test again at 90 minutes and 120 minutes. Generally, China Ozone Disinfector can detect the ozone concentration immediately after working for 30 minutes, and the normal working time is 1 hour; if the ozone concentration cannot be detected or is low, it is necessary to detect whether the ozone has entered the pipeline or whether there is leakage of ozone; if there is leakage of ozone, It will cause the ozone concentration to be low; if the ozone concentration in the detected air is too high, control the sterilization time.

The amount of ozone refers to the proportion of ozone per unit volume. The selected units are mg/L, g/m3, and the volume ratio units are 1%, 5%, etc. The health department commonly uses ppm. The above units are often used to indicate the outlet concentration or atmospheric ozone concentration of China Ozone Disinfector. The amount of ozone represents the sum of the weight of ozone per unit volume when the ozone device is produced. The larger the value is, the faster the ozone production equipment is to produce ozone. Because the ozone layer is unstable and breaks down on its own, it needs to be readily available.

A small ozone machine has a small generator. Switch machine. Temperature drop start. Low temperature start. Centrifugal generator. Balance. Alarm etc. Small structure: low-power generator high-voltage switch belt, low-voltage starter high-voltage collector. Low-voltage starter fuse. Automatic measurement control belt. Noise: Noise. The high temperature of the operating parts of China Ozone Disinfector is composed of instruments, output control circuits, software operating mechanisms and electrical components.